Und vielleicht kann mir bei der Gelegenheit jemand von Euch erklären, wie ich meine DX7 richtig auf den Blade zuschneide, zumal ich die 120° SwashPlate-Einstellungen mental noch nicht so ganz auf die Reihe bekomme
Spektrum DX7
In the “System Mode”:
Input Selection (INPUT SELECT)
GEAR = GYRO
Swashplate Type (SWASH TYPE)
3 SERVOS 120*
In the “Function Mode”:
Dual Rate and Exponential (D/R & EXP)
AILE 0 100% 15%
ELEV 0 100% 15%
RUDD 0 100% 15%
AILE 1 70% 10%
ELEV 1 70% 10%
RUDD 1 80% 10%
NOTE:
These values serve only as starting points. It may be necessary to decrease or increase the values per your preference.
Servo Reversing (REVERSING SW)
ELEV – R
AILE – R
RUDD – R
Travel Adjustment (TRAVEL ADJUST)
Transmitter Default
Swashplate Mixing (SWASH MIX)
AILE +100%
ELEV -100%
PITC +35%
Throttle Hold (THRO HOLD)
ACT HOLD Pos.
HOLD SW 0.0%
Throttle Curves (THRO CURVE)
NOTE:
The factory recommended normal mode throttle curve has been optimized for the power/torque band of the High-Power 370 and recommended brushless motor power system.
POS L POS 1 POS 2 POS 3 POS H
NORMAL 0.0% 45.0% 60.0% 75.0% 100.0%
STUNT 1 100.0% 75.0% 50.0% 75.0% 100.0%
STUNT 2 100.0% 100.0% 100.0% 100.0% 100.0%
HOLD - 0.0%
Pitch Curves (PITCH CURVE)
POS L POS 1 POS 2 POS 3 POS H
NORMAL 42.0% 46.0% 50.0% 75.0% 100.0%
STUNT 1 0.0% 25.0% 50.0% 75.0% 100.0%
STUNT 2 0.0% 25.0% 50.0% 75.0% 100.0%
HOLD 42.0% 46.0% 50.0% 75.0% 100.0%
Gyro Sensitivity (GYRO SENS)
AUTO
RATE:
0: 100%
1: 100%
NOTE:
These values serve only as starting points. It may be necessary to decrease or increase the values in order to achieve the proper gain setting value.
Timer (TIMER)
DOWN–T
4:30
After programming your chosen transmitter with the suggested initial settings, install the flight battery and test the controls as outlined in the following sections in order to be sure that the settings are correct for proper control and performance.
